Villager SSV 7050 RS, Руководство пользователя, Страница: 49 / 252

21
With the continuously variable electronic speed control (5), the cutting speed can be
increased by turning to the right or reduced by turning to the left.
Lighting system (8) (Fig. 1+17)
The lighting system can be switched on by pressing the switch (b) on the lamp.
The lighting system is switched off if the switch is pressed again.
To change the batteries (2x AAA R03 1.5), open the battery compartment on the bottom of
the light by removing the three screws (c) using a Phillips screwdriver.
Insert the new batteries. Dispose of the old batteries properly.
Fit the cover of the battery compartment in reverse order.
CAUTION: Do not stare at operating lamp.
9. Maintenance
Warning: In the interests of operational safety, always switch off the saw and remove the
mains plug before carrying out maintenance work.
General
Wipe chips and dust off the machine from time to time using a cloth.
Re-application of the wax coating on the workbench makes feeding the workpiece to the
blade easier.
Motor
The mains cable should be replaced immediately if pulled out, cut or damaged in any other
way.
Do not lubricate the motor bearings or internal parts!
Saw arm bearings
Lubricate the saw arm bearings every 50 hours. Proceed as follows (Fig. 18):
•
Turn the saw to the side.
• Apply a generous amount of SAE 20 oil to the shaft end and bronze bearings.
• Let the lubricant oil work in overnight.
•
Repeat the procedure the next day on the other side of the saw.
There are no parts inside the equipment which require additional maintenance.