Villager SSV 7050 RS, Руководство пользователя, Страница: 46 / 252

18
CHANGING THE SAW BLADES
Warning: Switch off the saw and remove the mains supply plug before installing saw
b!ades in order to avoid injuries caused by unintentiona activation of the saw!
A. Flat saw-blades, Fig. 6
Use the adapter with flat saw-blades.
The saw-blade is fixed with Allen screws.
A 1 Saw-blade removal, Fig. 7+8, 10
•
Extract the saw-blade by sliding the table's inlay (14) up, then unscrew the tightening
screw (1).
• Slightly press the upper arm (M) down (Fig. 10).
•
Then remove the sawblade by pulling it forward out of the supports and through the
access perforation in the table.
A 2 Inserting the saw-blade:
•
Put the saw-blade with the two adapters into the lower support, the other end into the
upper support.
•
Slightly press the upper arm (M) down (Fig. 10) before hooking it in.
•
Tighten the blade with the tightening screw (1) (Fig. 7) by rotating it clockwise. Check
the tightness of the blade. Keep on rotating clockwise in order to tighten the blade
even more.
B Saw-blade with pins
B 1 Saw blade removal, Fig. 7+10
• Extract the saw-blade by first unscrewing the tightening screw (1).
•
Remove the saw-blade from the upper and lower support by slightly pressing the saw's
upper arm down (Fig. 10, M).
B 2 Inserting the saw-blade, Fig. 7, 9-11
• Lead one end of the saw-blade through the perforation in the table and insert the saw-
blade pins into the notch. Repeat this procedure at the upper blade support.
•
Before hooking it in, slightly press the saw's upper arm down (Fig. 9, 10).
•
Check the position of the blade pins at the supports (Fig. 11).
• Tighten the blade by means of the tightening screw. Check the blade's tightness. Keep
on rotating clockwise in order to tighten the blade even more. (Fig. 7).