FEBERARY/06/2006
4. Within 10 seconds, press and release
button on the transmitter, one chirp to confirm the system in
features “RPM Learning mode”.
5. Within 10 seconds, start the vehicle with the key. (While the engine is running, the parking light & LED
will flash, If don’t, please check tach.
White/Red
wire connection.
6. Press and hold the valet switch for 2 seconds until a long chirp and the LED light constant for two
seconds. The RPM signal is learned.
7. Press button on the transmitter or turn the ignition switch off to exit the program mode. A 3 long
chirps & 3 parking light flashes to confirm exit.
RETURN TO FACTORY DEFAULT SETTING:
1. Turn the Ignition switch ‘On then Off 3 TIMES and stay in Off position.
2. Within 10 seconds, push and release the Valet switch 9 times and holding in on the
9
th
push until three
long chirps to confirm you are now in the “Return To Factory Default Setting” programming mode.
3. Press
button on the transmitter for 5 seconds, there will be a confirmation six chirp with one long
chirp to confirm the system “ Feature Programming all returns to factory default setting.
SHUTDOWN DIAGNOSTICS
The unit has the ability to report the cause of the last shutdown of the remote start system.
Enter:
1. Turn the Ignition switch to ‘On’ position.
2. Press the
button on the transmitter.
3. The LED will now report the last system shutdown by flashing for one minute in the following grouped
patterns:
LED
Flashes
Shutdown Mode
1
(-) Safety Shutdown input (Hood)
1. Close the hood.
2. Check White/ Black wire connection.
2
(+) Safety Shutdown input (Brake) or
1. Check White/ Violet wire connection.
Neutral Safety Switch input fail
2. Move the Enable Toggle Switch to “ON”
position. (If installed.)
3. Move the gear selector to “Park”/ “NEUTRAL”
position.
4. Check Black/White wire connection.
3
No RPM (Engine Checking TACH.) or
Check White/Red wire connection
Low Voltage. (Engine Checking
Voltage.
Program the “CHECK LEVEL” from
“Hi Check Level” to “Low Check Level”
5
Over-rev
6
System timed out
7
Transmitter
8
Tach. Signal has not been learned
Re-learning the RPM (Start Feature
3
)
TESTING YOUR INSTALLATION:
Caution!!
The follow procedure must be performed after the installation of the Remote Start Device. It is the
responsibility of the installing technician to complete these tests. Failure to test the unit in the following
manner may result in personal injury, property damage, or both.
1. Test the BRAKE shutdown circuit: With the vehicle in park (P), start the vehicle using the remote
transmitter, Once the engine is running, press the brake pedal. The vehicle should shut down immediately.
If the vehicle continues to run, check the brake circuit WHITE/ VIOLET
wire connection.
2. Test the HOOD PIN shutdown circuit: Start the vehicle using the remote transmitter, Once the engine is
running, pull the hood release and raise the hood. The vehicle should shut down immediately. If the
vehicle continues to run, check the hood pin WHITE/ BLACK wire connection.
3. NEUTRAL START SAFETY TEST:
1. Set the vehicle parking brake.
2. Block the drive wheels to prevent vehicle movement.
3. Sitting in the vehicle, turn the ignition switch to “ON” or “RUN” position. But do not start the engine.
4. Step on the brake pedal and shift the gear selector into “DRIVE” (D).
5. Put your foot over the brake pedal but do not press down on it. Be ready to step on the brake to shut
down the Remote Start Device.
6. Start the vehicle using remote transmitter.
a.
If the starter does not engage, the test is complete.
VS3725IN
14
