5
C. Using a Video Encoder to Convert the Analog NTSC Video to IP
Axis manufactures video servers that encode analog video signal for
transmission across IP network or the internet. The single channel model
M7011
is shown. Supplied software allows you to access Axis units connected to the
network (auto-discovery) and program them via a web page interface. The video
can then be monitored from any location on the network.
For more information, go to
www.axis.com
Axis Model
M7011 shown
D. Adjusting the Camera
Vertical (Tilt)
Adjustment
+/- 20 degrees
maximum
Horizontal (Rotation)
Adjustment
+/- 30 degrees
maximum
1
2
ABC
5
JKL
8
TUV
0
OPER
4
GHI
7
PRS
#
3
DEF
6
MNO
9
WXY
VIKING
©
The camera can be tilted and rotated to
your desired position. A portable service
(test) monitor can be used to determine the
correct viewing angle during installation.
Important:
To prevent the edge of the
faceplate from being viewed in the video
image, do not rotate the camera beyond 30
degrees or tilt beyond 20 degrees.
VIKING
Model:
XXXXXX
XXXXXX
Serial No:
XXXXXXXX
P/N:
DEV
:
Microphone Volume
(see section B)
Speaker Volume
(see section B)
ON OFF
DIP Switches
(shown in default
positions)
OFF
OFF
Rear View of
the K-1775-3
4
3
2
1
8
7
6
5
VIKIN
G
M
odel
:
XXXXXX
X
XXXX
X
Serial No
:
X
XXXXXXX
P/
N
:
DEV
:
Programming
A. DIP Switches
Switch 1
Switch 2 Maximum Call Time
OFF
OFF
Disabled (default)
ON
OFF
1 Minute
OFF
ON
3 Minutes
ON
ON
9 Minutes
Switch 5
Switch 6 Audio Detection
ON
ON
Normal Audio detection
OFF
OFF
Increase audio detect sensitivity for
low level lines. Useful in applications
in which voice or busy signals have
trouble breaking over the speaker.
Switch 3 Disconnect on Dial Tone
OFF
Off
ON
On(default)
Switch 4 VOX Switching Speed
OFF
Fast, 0.2 sec. (default)
ON
Slow, 0.7 seconds
Switch 7 Auto Answer Position
OFF
Automatic answer disabled
ON
Automatic answer enabled (default)
Switch 8 Push Button Feature
OFF
Connects calls only
ON
Connects/disconnects c alls (default)
B. Volume Adjustments
2. Speaker
Certain noisy locations (background traffic, machinery or wind) may cause one way talk path (only microphone audio is heard).
In this case, the microphone volume may need to be decreased as shown.
To increase, decrease or turn off the speaker (for monitoring purposes only), adjust the speaker volume control as shown.
1. Microphone
