Viking FDWB301, Руководство по установке

Страница: 14 / 18

27
26
Back side of wine cellar
Red, white, and black
wiring*
*Black = common
Red = normally closed
White = normally open
Home Security System Connection
NOTE: Contact a qualified electrician or authorized agent from alarm company to connect your
home security system to the wine cellar.
Home security system connection must be hooked up before the unit is installed.
1. Remove the four mounting screws attaching the unit compartment cover to the cabinet. (2
per side)
2. Remove the grille louver assembly to access the black safety grille.
3. Turn power off.
4. Remove the four screws that attach the top grille assembly to the mounting brackets.
5. Remove the 3 screws at the right side of the unit that attach the safety grille to the
compartment cover.
6. Choose the desired switching position and connect according to alarm system requirements.
7. Replace the unit compartment cover.
The home security system will be activated if temperatures in the wine cellar fluctuate outside of
the set point by 5° for and extended time period.
Securing Your Wine Cellar
(3 options)
WARNING
ELECTRICAL SHOCK HAZARD
Disconnect power at breaker or turn power
disconnect switch to OFF position before
performing any installation procedure. Failure
to do so can result in death or electrical shock.
Solid Soffit
1”
(2.5 cm)
or less
Rear
Wall
OPTION 1
1/4” (0.6 cm)
maximum
2”
(5.0 cm)
minimum
Two 2 x 4
boards
attached to
wall with six
wood screws
(minimum)
OPTION 2
1/4” (0.6 cm)
maximum
3”
(7.6 cm)
minimum
“L” bracket
with (4) screws
on each end.
(1) 2x4
attached to
both “L”
brackets -
minimum of
1” (2.5 cm) screws.
Screws extend
minimum of
1” (2.5 cm) into
each wall stud.
OPTION 3
OPTION 1
If a solid soffit is 1” (2.5 cm) or less above the wine cellar, anti-tip boards are not required. To
secure the wine cellar raise unit until compartment is firmly seated under the soffit.
OPTION 2
If a solid soffit is not available or soffit is more than 1” (2.5 cm) above wine cellar, center wood
boards on rear wall 1/4” (0.6 cm) maximum above wine cellar. Attach wood boards to wall studs
with six of the provided wood screws, making sure that screws are engaged in wall studs 1-1/2”
(3.8 cm) minimum and that boards extend 2” (5.0 cm) minimum over the top rear of wine cellar
compressor cover. To secure the wine cellar, raise unit until compartment is firmly seated under the
anti-tip board.
OPTION 3
Position the wood block over the unit and secure it to wall studs using eight of the provided wood
screws and “L” brackets. Make sure screws extend a minimum of 1” (2.5 cm) into each of the two
wall studs. The wood block must extend a minimum of 3” (7.6 cm) over the unit. To secure the
wine cellar, raise unit until compartment is firmly seated under the anti-tip boards.