![Viking Designer DEDO530SS Скачать руководство пользователя страница 36](http://html1.mh-extra.com/html/viking/designer-dedo530ss/designer-dedo530ss_service-notebook_1023511036.webp)
36
Convection Motor Capacitors
Removal
The Convection Motor Capacitors are located
above the oven cavity in the front of the
component compartment. They are used to control
the direction and speed of convection motor. Each
convection motor has two capacitors.
WARNING:
Disconnect power to oven
before servicing. Follow lockout/tagout
procedures.
CAUTION:
Some areas of the oven
interior are sharp; wear protective gloves to
avoid injury.
Condition Requirements:
Partial Access to Control Components
1.
Remove two screws from each side of the
control panel assembly.
2.
Lower the control panel assembly forward
leaving the panel in the three tabs along
the bottom of the panel.
CAUTION:
Use care when lifting the
control panel assembly from the tabs. The
weight of the control panel assembly could
pull wires from connectors. It will be
necessary to remove some connectors from the
control panel assembly or the control board to
gain access to the bottom of the capacitor. Tag
and mark any connectors before removal.
3.
Lift the control panel off three tabs.
WARNING:
A capacitor may maintain
a charge even after power has been
disconnected. Use care when discharging
the capacitor to avoid electric shock.
4.
Discharge the capacitor and then
disconnect two connectors from the
capacitor.
5.
Remove 13mm nut and capacitor from the
oven.
6.
Reverse procedure for installation.
Содержание Designer DEDO530SS
Страница 18: ...18 Service Procedures Part Locator...
Страница 50: ...50 Oven Control Board Oven Control Board Connections...
Страница 68: ...68...