Viking DDFF136, Руководство по установке

Страница: 12 / 16

23 22
1
2
Pull both rails out to full extension. Insert the screws in the top of the drawer front into the
slots in the drawer brackets.
3 4
Pull the drawer brackets toward you to position the
screw in the bottom of the drawer front into the
brackets. Repeat for both sides of drawer.
Completely tighten the four screws on both sides of
drawer.
Freezer Drawer Reinstallation
(Bottom-Mount)
5
Push drawer closed.
24
” d
ia.
(60
.9
cm
) m
in.
24
” d
ia.
(60
.9
cm
) m
in.
1
2
Create service loop with copper tubing (minimum 2
feet diameter). Avoid kinks in the copper tubing when
bending the service loop. Do not use plastic tubing.
Remove plastic cap from water valve inlet port.
Installation
Materials Needed
• 1/4” outer diameter flexible copper tubing
• Shut-off valve (requires a 1/4” hole to be drilled into water supply line before valve
attachment)
• 2 adjustable wrenches
• 1/4” hex nut driver
NOTE: Use copper tubing only for installation. Plastic is less durable and can cause damage.
Add 8 feet to tubing length needed to reach water supply for creation of service loop.
Connect to Water Supply
3
Brass nut
Sleeve
4
Place brass nut and sleeve on copper tube end as
illustrated. Remember: Do not use old sleeve. The nut
and the sleeve are provided in the consumer literature
packet.
Place end of copper tubing into water valve inlet port.
Shape tubing slightly. Do not kink—so that tubing
feeds straight into inlet port.