35
34
1-1
3/1
6”
(4.6
cm
)
1-1/2”x 3/4”
(3.8 cm) x (1.9 cm)
wood strip
1
5/16”
nut driver
Slot for
wood strip
2
5/16”
nut driver
Measure down 1-13/16 (4.6 cm) from desired height of
hood and secure 1-1/2” x 3/4” wood strip (not
included) to wall using screws provided.
Use additional mounting screws to secure hood to
wood strip.
Installation
(DCWH/DCWN/DCWL Classic Chimney & DTWL/DTWN Tall Traditional Wall Hoods)
3
5/16”
nut driver
5/16”
nut driver
CAUTION:
Secure vent hood to wall using screws provided.
Make sure mounting screws are secured into frame. Use
additional mounting screws and wall anchors, if necessary.
CAUTION:
If not using a duct cover, using screws provided
make sure top mounting screws are secured into soffit or
cabinet frame. Use additional mounting screws, if necessary.
To install ventillation kit
refer to ventillation kit
installation instructions.
1
2
3
4
Slide filter front over front lip. Push filter rear up, then
slide back over rear lip.
1
2
3
5
Slide spacer front over front lip. Push spacer rear up,
then slide back over rear lip.
1
2
3
6
Slide filter front over front lip. Push filter rear up, then
slide back over rear lip.
1
2
Measure distance from ceiling to canopy.
Tape to avoid scratching.
Duct Cover Option
(DCWH/DCWN/DCWL Classic Chimney Wall Hoods)
Slide filter front over front lip. Push filter rear up, then
slide back over rear lip.
2
1
3
13
Slide spacer front over front lip. Push spacer rear up,
then slide back over rear lip.
2
1
3
12
