Viking Built-in French Door Bottom-Freezer Refrigerator, Руководство по установке

Страница: 10 / 12

19 18
Final Installation Final Installation
5. Remove the 2 door stop screws.
• To remove the outer screw (“A”):
With the door closed, firmly press the L-
shaped bracket toward the center of the
refrigerator until the screw is exposed.
• To remove the inner screw (“B”):
Open the door 90° and the L-shaped
bracket will expose the screw.
A
B
6. Reverse or rotate the door stop to the
desired position as shown below.
90 o 110 o
130 o
7. Replace the door screws and tighten.
8. Check that the door can open freely.
Left-hand as shown; Right-hand reversed
IIn nsstta allll B Ba asse e G Grriilllle e
There are two pieces to the base grille to
allow for a custom fit:
the base grille itself and the skirt.
The skirt can be added to the base grille in
order to extend it all the way to the floor.
1. To see whether the skirt is needed, place
the base grille into position. Do not attach
the base grille to the refrigerator.
Measure the distance between the
bottom of the base grille and the floor.
The gap must be a minimum of 1/2" (1.27
cm) in order to add the skirt.
N NO OT TE E: If the gap measures less than 1/2”
(1.27 cm), skip steps 3 and 4 of the
instructions, and install the base grille
only.
2. Remove the film from the base grille.
3. Snap the skirt
onto the
base grille.
Base grille
Skirt
4. Trim the skirt by scoring the proper “V”
groove with a utility knife. Break the skirt
at the score line.
“V” groove
5. Using the two screws, attach the base
grille assembly to the refirgerator as
shown.
N NO OT TE E:: Drive in the right side screw first.
Screws
4. The door stop is located on the top
hinge.
Screw
B
Screw
A
Door
Stop
D Do oo orr S Sw wiin ng g A Ad djju ussttm me en ntt
(con’t)