Preparation for Use
Preparation for Use
Unpacking
• Strobe Light Fixture
• User manual
• DMX cable
• Mains power cable
• Trunion Arm Bracket, 2 Arm Knobs, Half Coupler Bracket & Hex Screws, Safety Eye
The packing material protects the fixture during shipment, please retain for future transportation of
the fixture.
AC Power Connection
The auto-ranging power supply automatically adjusts to AC power from 208-240 volts nominal at
50/60 Hz.
The current required by the light is 4 amps. To avoid overload, allow one 4 amp branch circuit per
fixture to operate the light model at full power.
Use 2.5 mm2 (13 AWG) or larger power feed cables and keep runs as short as possible.
The power cable colur coding is given in the table.
• Connect the brown wire to live
• Connect the blue wire to neutral
• Connect the green/yellow wire to ground (earth)
The device must be grounded / earthed and be able to be isolated from AC power. The AC
power supply must incorporate a fuse or circuit breaker for fault protection.
To rig the fixture
！
Before installing;
•
Verify that the attachment hardware is in good condition and designed to carry at least 10 times
the fixture’s weight.
•
Verify that the structure can support at least 10 times the weight of all installed fixtures, clamps,
cables, auxiliary equipment, etc.
•
Verify that the clearance around the air vents is at least 0.1 meters (4 in.).
•
Loosen the mounting bracket and adjust the fixture to the desired angle.
•
Connect and arrange the power and data cables.
•
Use a safety bond if 15kg rating or higher and wrap around the Trunion Arm for single units or
attach the Safety Eye to Trunion Arm Mounting Hole if building into multiple displays
Always use a secure means of secondary fixing such as a safety wire
