OPERATION
INSTRUCTIONS
VS100/500
INITIAL START-UP
When your spa is first activated, it will go into
Priming mode, indicat-ed by “Pr”. The priming mode
will last for less than 5 minutes. Then, the spa will
begin to heat and maintain the water temperature in
the Standard mode indicated by
“St”
.
TEMPERATURE (26°C - 40°C)
The start-up temperature is set at 37°C. The last
temperature is constantly displayed on the LCD.
Note: The last spa temperature displayed is current
only when the pump has been running for at least 2
minutes.
TOPSIDE CONTROL INSTRUCTIONS
(All Models except Royale ETS, Regal ETS, Legacy, Legend, Heritage & Tradition)
Indicator Light
Press the “Temp” button to display the temperature previously set. The set temperature flashes on the
display. Pressing the “Temp” button a second time, while it is still flashing, will cause the set temperature to
increase or decrease depending on what direction was last chosen. Each press to follow will change the set
temperature in the same direc-tion. If the opposite direction is desired, release the pad and let the display
revert to the actual water temperature. Press the button to dis-play the set temperature, and press again to
make the temperature change in the desired direction. After three seconds, the LCD will stop flashing and
display the current spa temperature.
Sets Water
Temperature
Heat on
Turns Light
On/Off
Sets Water
Controls Low Speed/
High Speed Pump
08
