Viking Range VMTK272, Руководство по установке

Страница: 4 / 24

3 E
Cabinet or Wall Cutout
Provide an opening in the wall or cabinet as indicated
in figure
1
. The depth should be a minimum of 20-1/8"
(51.1 cm). If the Depth (C) dimension is greater than 21"
(53.3 cm), the outlet location may be in any area on the
rear wall. The floor of the opening should be constructed
of plywood strong enough to support the weight of the
oven (about 100 lbs.) and should be level for proper
operation of the oven.
Note: while the proper functioning of the oven does not
require that the opening be enclosed (with sides, ceiling
and rear partition), this may be required by local code,
and it is suggested that the local code be checked for
any such requirement.
A
B
D
E
C
1
Surface Mount Cutout Dimensions
* for flush mount dimensions please see installation template and
FLuSh MOuNT INSTALLATION on page 5-6.
CONVECTION CONVENTIONAL
(a) Height
18-1/2" (46.9 cm) min. 16-3/4" (42.5 cm)
max. 17" (43.2 cm)
(B) width
25" (63.5 cm) min. 24-3/8" (61.9 cm)
max. 24-11/16" (62.7 cm)
(C) Depth min. 20-1/8" (51.1 cm) min. 20-1/8" (51.1 cm)
(D)
min.
max. 6"
11-1/2" (15.2 cm)
(29.2 cm)
(E)
min.
max. 4"
5" (10.2 cm)
(12.7 cm)
ELECTRICAL OuTLET LOCATION: Outlet should NOT be in the
shaded area as indicated on figure
1
. at the rear of the opening,
provide a 3-pronged, polarized, electrical outlet, 115-120 volt aC,
15 amp or larger.
2
DUCT (C)
DUCT (B)
SCREw (a)
EXhAuST DuCT ASSEMBLY: Insert the edge of DUCT (B) into the
hold lip of DUCT (C). Secure together by using a SCREw (a) provided
in the kit. See figure
2
.
3
SCREw (a)
DUCT (a)-1
DUCT (BC)
SCREw (a)
EXhAuST DuCT ASSEMBLY: Position DUCT (a)-1 on the top of the
oven inserting edge of DUCT (BC) assembly into hole lip of DUCT
(a)-1. Tighten two SCREwS (a), securing DUCT (a)-1 to DUCT (BC)
assembly. See figure 3 .
4
SCREw (a)
SCREw (a)
DUCT (a)-2
DUCT (a)-1
EXhAuST DuCT ASSEMBLY: Position DUCT (a)-2 on the top of the
oven and insert it into the hold lip of DUCT (a)-1. Secure DUCT (a)-2
to DUCT (a)-1 using two SCREwS (a) provided. See figure 4 .
5
SCREw (a)
SCREw (a)
SCREw
(a)
DUCT (a)-3
DUCT (a)-2
EXhAuST DuCT ASSEMBLY: Position DUCT (a)-3 on top of the oven
and insert it into DUCT (a)-2. Secure DUCT (a)-3 using three screws
(a) provided. See figure 5 .
Exhaust Duct Assembly