manualshive.com logo in svg
background image

13

2

1

2

3

2

2

1

Open door completely. Place pin in pin hole.

Note: 

Two pins included.

Remove hinge trim screws. Take off hinge trim.

5

Close until pins stop door.

Lift door up and out.

Note: 

Do not lift door using handle.

NOTICE

DO NOT

use the handle or oven door to

lift the oven. Remove door before
installation to ensure that it is not used to
lift the unit. 

DO NOT

lift or carry the door

by the handle.

Removing the door must be done by your
dealer, a qualified licensed plumber, or
certified gas installer.

Installation

1

Remove wooden brace on front of pallet.

Door Removal 

Installation

12

Note:

A minimum of 2” spacing above and

below the oven to any adjacent items is
required for ventilation purposes.

• It is recommended that 3/4” or larger

material be utilized to create a support
platform for this appliance.

• 

BE SURE

that support for this appliance is

perpendicular to the front facing of the
wall or cabinet before you perform the
installation.

• Use of a hydraulic lift is recommended for

the installation of double oven units.

• All openings in the wall behind the

appliance or in the floor under the
appliance should be sealed.

• Keep appliance area clear and free from

combustible materials, gasoline and other
flammable vapors.

• 

WARNING: DO NOT 

USE AN

EXTENSION CORD WITH THIS
APPLIANCE.  SUCH USE MAY RESULT IN
FIRE, ELECTRICAL SHOCK OR  OTHER
PERSONAL INJURY.

General Information

(cont.)

Recommendations for Moving

• The appliance is heavy – use extreme care

when handling!

NOTICE

DO NOT

use the handle or oven door to

lift the oven. Remove door before
installation to ensure that it is not used to
lift the unit. 

DO NOT

lift or carry the door

by the handle.

Removing the door must be done by your
dealer, a qualified licensed plumber, or
certified gas installer.

• Only proper equipment should be used to

move products.

• 

ALWAYS

take steps to protect flooring at

the installation location when moving

products.

Site Preparation

Note:

It is recommended that a thorough

site inspection be conducted PRIOR to
unpacking and moving this appliance.

• 

WARNING: DO NOT

use the handle or

oven door to lift the oven. Remove door
before installation to ensure that it is not
used to lift the unit. Make sure pins are
inserted into hinges before removing door
to prevent personal injury to hands and/or
fingers.  

Do not lift or carry the door by

the handle.

• Confirm available access to adequate

power – see electrical requirements.

All manuals and user guides at all-guides.com

Содержание Brigade CVGSO100











Отзывы: