15
Automatic Ice Maker
Ice maker operation & care
After the refrigerator is installed properly, the ice maker can
produce ice within 24 hours. It can completely fi ll an ice bin
in about three days.
When using the ice maker for the fi rst time and in order
for the ice maker to work properly, it is necessary to clear
air from water fi lter tubing. Once ice maker begins making
ice, allow the bucket to fi ll completely, then discard the fi rst
TWO FULL buckets of ice. It will take at least two days to
completely fi ll the bucket on regular ice making mode or 1
½
days on fast ice mode.
The ice maker produces approximately 2 to 2.5 lbs (0.9 to 1.1
kg) of ice every 24 hours depending on usage conditions.
The ice bin will hold approximately 7 lbs (3.2 kg) of ice.
IMPORTANT
Your ice maker is turned on at the factory so it can work as
soon as you install your refrigerator. If you cannot connect
a water supply, lift the ice maker’s wire signal arm to turn it
off. Otherwise, the ice maker’s fi ll valve may make a loud
chattering noise when it attempts to operate without water.
Turning the ice maker on and off
Ice production is controlled by lifting/lowering the ice maker’s
wire signal arm
. To gain access to the ice maker, pull the
freezer drawer out. Lift the wire signal arm to turn the ice
maker OFF and lower the wire signal arm to turn it ON.
Ice maker tips
• If your refrigerator is not connected to a water supply
or the water supply is turned off, turn off the ice maker
by lifting wire signal arm.
Cleaning the ice maker
Clean the ice maker and ice bin at regular intervals, especially
prior to vacation or moving.
1.
Turn off the ice maker.
2.
Remove the ice bin.
3.
Empty and carefully clean the ice bin with mild
detergent. Do not use harsh or abrasive cleaners. Rinse
with clean water.
4.
Allow the ice bin to dry completely before replacing in
the freezer.
5.
Replace the ice bin. Turn the ice maker on.
Remove and empty the ice bin if:
• An extended power failure (one hour or longer) causes
ice cubes in the ice bin to melt and freeze together.
Remove the ice bin and shake to loosen the cubes or clean
as explained above.
CAUTION
If the water supply to your refrigerator is softened,
be sure the softener is properly maintained.
Chemicals from a water softener can damage the ice
maker.
CAUTION
NEVER use an ice pick or similar sharp instrument to
break up the ice. This could damage the ice bin.
To loosen stuck ice, use warm water. Before
replacing the ice bin, make sure it is completely dry.
• The following sounds are normal when the ice maker
is operating:
-
Motor
running
- Ice dropping into ice bin
- Water valve opening or closing
-
Running
water
• Ice cubes stored too long may develop an odd fl avor.
Empty the ice bin as explained below.
Fast Ice Function
Your refrigerator is equipped with a Fast Ice Function, that
will, if activated at your user interface, allow an increase in ice
production. You do not need to deactivate it, if not needed,
your refrigerator will operate on normal conditions.
Содержание 3 Series
Страница 31: ...31 ...
