VIKING GARDEN MT 4097 S, Инструкция по эксплуатации

Страница: 42 / 306

0478 192 9804 B - EN
40
14.13 Changing the engine oil
Information regarding the specified engine
oil and oil capacity can be found in the
engine instruction manual.
Perform an oil change when the engine is
warm to the touch. Place a suitable oil
collection container (note engine oil
capacity) under the oil drain tube.
Dispose of used oil in conformance with
statutory requirements.
Oil change interval:
The recommended oil change intervals
can be found in the engine instruction
manual.
Draining the engine oil:
● Stop the engine. ( Ö 12.3)
● Engage the parking brake. ( Ö 8.12)
● Remove the ignition key and keep it in a
safe place.
● Allow the engine to cool down (warm to
the touch).
● Open the engine hood. ( Ö 14.3)
● Unscrew the oil cap (see engine
instruction manual).
The oil drain tube (1) is located on the
right-hand side of the engine, near the two
pedals.
● Place a suitable oil collecting container
underneath.
Using two spanners (A/F 19/A/F 15),
unscrew oil drain plug (1) and remove.
Drain all the engine oil.
Fit seal ring (2) onto oil drain plug (1).
Screw in oil drain plug (1) and tighten.
Tightening torque: 12 - 14 Nm
14.14 Topping up engine oil
● Open the engine hood. ( Ö 14.3)
● Check the engine oil filling
level. (
Ö 14.12)
● Top up the engine oil as per the engine
instruction manual – use a suitable
funnel.
● Close the engine hood. ( Ö 14.4)
14.15 Replacing headlamp bulbs
● Open the engine hood. ( Ö 14.3)
Turn socket (1) through approx. 90° and it
pull out.
Risk of injury!
Allow the engine to cool down
before topping up the engine oil or
before changing the oil.
Danger of burns due to hot engine
oil.
Avoid damage to the machine.
Avoid exceeding and falling below
the correct engine oil level.
When replacing defective lamp
bulbs, always use 12V bulbs rated
at 6W.
Bulb designation:
12V 6W BA9s