VIGOUROUX Attalink-3A, Детали, особенности и регулировки

Страница: 9 / 18

9
Part n°12 – Aluminium reel spool bracket
Holds the metal reel spool. When the spool is fitted to its bracket, the reel
feed slit in the plastic box must be located exactly opposite the thread dis-
penser.
See the
ATTALINK
instruction manual (drawing n°14)
Part n°1 – Large arm (part n°1 for
ATTALINK
-3A and part n°6-1 for
ATTALINK
-6A)
Its upper end positions the thread feed so that it can be gripped by the
thread blocking device (part n° 19N).
The angle of the upper end must match the description for photo 18 in
paragraph VII of the adjustment manual.
The curve of the guard has an effect on the travel of the thread advancer
(part n°11). In cases of extreme wear, the play on the thread advancer can
be taken up when the tool is in closed position by nudging back the guard
towards the thread advancer.
Part n°10 – Main axle and retaining clips
To remove and refit the axle, use the same procedure as applies to part
n°22.
Part n°22 – Play on the sliding axle
Extensive wear may limit the travel of the thread advancer. This part should
then be changed. Refer to paragraph VIII of the adjustment manual.