VIGOUROUX Attalink-3A, Детали, особенности и регулировки

Страница: 14 / 18

14
2- If necessary, adjust the point at which the metal is cut. To do this, operate the pincers
very slowly holding the plastic end of the thread block (part n°19N) with a finger until the
metal cutter clicks shut (photo 15).
This should happen when the plastic edge of the thread block (arrow A on photo 15) is lo-
cated in the zone shown on photo 15. If cutting occurs before this, fold the angle of rod n°
13 (arrow B of photo 16) further; if it occurs later, straighten the rod (arrow A of photo 16).
Use the tools we provide for this.
3- Carry out the operations described in 1 and 2 above one after the other, as each adjust-
ment impacts on the next. It is also recommended to make these adjustments gradually in
small incremental steps.
VI- Changing the thread cutter (part n°4A)
a- On the
ATTALINK
-3A only, remove the recall spring (part n°14C)
b- Unscrew the maintaining screw (part n°15) from the casing feed (pièce n°18A) and re-
move it.
c- Unscrew screw n°3 maintaining the thread cutter (part n°4A) and retainer (part n°25).
d- Replace the thread cutter and relocate the retainer.
e- Screw the screw maintaining the cutter/retainer in position back.
f- Return the casing (part n°18A) to its original position.
g- Screw together the casing and the thread cutter (part
n°20C) keeping the sides of the arm tight level with the
axis of the thread retainer.
In the case of the
ATTALINK -3A , reconnect the recall
spring.
h- Check that the blade will fit easily into the slot of the
guillotine (part n°5 C) as the pincers close.
N.B. : For how to adjust parts n°4 on support n°18, please send your request by e-mail.
VII- Thread blocking device (part n°19N)
The thread support device is at an angle of 90 to 95° in relation to the upright of the pincer
arm (photo 18). Maintain this angle for the thread to feed correctly.
17
90 – 95 °
18 19 20