8/9
1. Instructions of main control board C1.
The Motor L and R
interface should connect to the left and right motor. Control
interface should connect to the 3Pin wire of C2. In general,
there is no need to adjust the motor drive current.
2. Instructions of switchboard C4. The left 3Pin interface is for
servo and the right interfaces are for laser. Please not that
never connect the servo to the right interface or the servo will
be burned. And note that the flat wire interface of C4 is drawer
type.
3. The flat wire interface of C4
is drawer type. Please lift the
lock up first.
4. Insert the flat wire the hard
contact behind.
5. Press the lock down.
6. The flat wire interface of C2
and C3 are both flip type.
Please turn the lock up first.
7. Insert the flat wire with the
hard contact down.
8. Press the lock down.
9. Instruction of servo. The
orange line on servo is the
PWM signal line
10. The switchboard C4 after
the connection.
11. The switchboard C3 after
the connection.
12. The switchboard C3 after
the connection.
13. The main control board C1
after the connection.
14. The main control board C1
after the installation.
