Viglen BX130, Руководство пользователя

Страница: 73 / 83

Viglen BX130 – VIG385P User Manual
72
CMOS Clear
JBT1 is used to clear CMOS. In-stead of pins, this "jumper" consists of contact pads
to prevent the accidental clearing of CMOS. To clear CMOS, use a metal object such
as a small screwdriver to touch both pads at the same time to short the connection.
Always remove the AC power cord from the system before clearing CMOS. JBT1 is
located near the SATA header on the Motherboard.
Note: For an ATX power supply, you must completely shut down the system, remove
the AC power cord and then short JBT1 to clear CMOS. Do not use the PW_ON
connector to clear CMOS.
USB Wake-Up
Jumper JPUSB is used in conjunction with the Keyboard Wake-Up function in BIOS
when you wish to wake the system up with a USB keyboard that has been
connected to a USB port (not header). Set JPUSB to pins 1-2 to support USB
keyboard wake-up and resume from ACPI S1 mode and pins 2-3 pins to support
USB keyboard wake-up and resume from ACPI S3 mode. See the table below for
jumper settings.
Note: Your power supply must provide 5v of standby voltage with at least 1A
to use this feature.
Watch Dog
JP5 enables the Watch Dog function. Watch Dog is a system monitor that can reboot
the system when a software application is "hung up". Pins 1-2 will cause WD to reset
the system if an application is "hung up". Pins 2-3 will generate a non-maskable
interrupt signal for the application that is "hung up". See the table on the right for
jumper settings.