VigilLink VL-IPSC-1, Руководство пользователя

Страница: 14 / 31

12/29
Operating Instructions:
(1) If an Encoder shows “No Signal”, it means that the Encoder cannot be
dragged.
(2) If there is an image on an Encoder, it means that the Encoder can be
dragged. As shown in the figure above, if an Encoder is dragged to the
place where the red arrow points to, all Decoders will share the same
signal resource from this Encoder; if an Encoder is dragged to the place
where the blue arrow points to, only the indicated Decoder can receive
signals from this Encoder.
■ Project Page
①
Current Devices: Devices that have been added to the current project.
②
Unassigned Devices: Devices not added to the current project.
Operating Instructions:
(1) Click “Display ID” to display the ID or PATTERN of the Decoders.
(2) Click “Save Project” to save the project file (config_file.json), so that you
can use the saved project next time without scanning devices again.
(3) Click “Load Project” to load the existing project directly.
(4) Click “Clear Project” to clear the current project, then you will need to
setup the project again.