VZ-CMK01
Installation Instructions
Visit the ViewZ website at http://www.viewzusa.com
Page 9
Attaching the Flat Panel to the VZ-CMK01A Mount
1) Insert two (2) M4 screws into the top two mounting points of your flat panel or VZ-AP200 Adapter Plate. Thread
the M4 screws to one-half of their length into the flat panel or VZ-AP200 Adapter Plate, but do not tighten the M4
screws at this time.
The length of the M4 screws are dependent upon whether or not you are using the VZ-AP200 Adapter Plate, as
shown below. Make certain you use the correct length for your specific installation.
If you are using the VZ-AP200 Adapter Plate, use the B mounting points. Refer to the
“Technical Specifications”
section for VZ-AP200 Adapter Plate mounting points.
2) Insert the heads of the M4 screws through the keyhole slots.
3) Insert two (2) M4 screws, of the proper length for your installation, into the bottom mounting points.
4)
Tighten all M4 screws.
Do not overtighten the mounting hardware.
Proceed to the “Adjusting the Mount Tension” section.
Flat Panel without VZ-AP200 Adapter Plate
Flat Panel with VZ-AP200 Adapter Plate
Thread Insert in Flat Panel
or Adapter Plate
VZ-CMK01A
Mount
Keyhole Slot
M4 Screw Partially
Threaded Into Flat Panel
or Adapter Plate
M4 x 5mm Screw
M4 x 10mm Screw
