VZ-CMK01
Page 6
Visit the ViewZ website at http://www.viewzusa.com
Installation Instructions
The VZ-CMK01A allows tilt and pivot adjustments ±15° from center, 360° side-to-side swivel, and cable access.
Please read these installation instructions once thoroughly before attempting to install your ViewZ product.
The VZ-CMK01A may be attached to 1-
½
˝ standard threaded pipe (NPT), or one of ViewZ adjustable-height
ceiling adapters. Please refer to the installation instructions that come with these adapters.
Please take a minute to familiarize yourself with the contents of the package and make sure you have all the parts and
tools you need to safely complete the installation.
In addition, some steps of this installation may require two people to prevent personal injury and/or damage to
your projector. Please observe all warnings in the following installation procedure and utilize proper safety
equipment at all times.
Installing the VZ-CMK01A Mount
Introduction
Attaching the VZ-CMK01A
Screw the VZ-CMK01A coupling adapter to the 1½˝
NPT.
The VZ-CMK01A must be threaded four complete
turns before tightening down the set screw.
If you are having difficulty achieving four complete
turns, insert a screwdriver through the access hole
and apply pressure while turning the VZ-CMK01A
(see below).
The desired ceiling attachment must be installed
prior to peforming the following steps.
