Viega Profipress S, Инструкция по эксплуатации

Страница: 14 / 24

3 Handling
3.1 Transport
Observe the following when transporting pipes:
n
Do not pull the pipes over the sill. The surface could be damaged.
n
Secure pipes during transportation. Pipes may become bent due to
shifting.
n
Do not damage the protective caps on the pipe ends and do not
remove them until immediately before mounting. Damaged pipe
ends may not be pressed.
In addition, observe the instructions provided by the pipe
manufacturer.
3.2 Storage
For storage, comply with the requirements specified in the applicable
regulations, see Ä „Regulations from section: Storage“ on page 6 :
n
Store components in a clean and dry place.
n
Do not store the components directly on the floor.
n
Provide at least three points of support for the storage of pipes.
n
Where possible, store different sizes separately.
Store small sizes on top of larger sizes if separate storage is not pos‐
sible.
In addition, observe the instructions provided by the pipe
manufacturer.
3.3 Assembly information
3.3.1 Mounting instructions
System components may, in some cases, become damaged through
transportation and storage.
n
Check all parts.
n
Replace damaged components.
n
Do not repair damaged components.
n
Contaminated components may not be installed.
Checking system components
Handling
Profipress S 14 from 24