Vido WD060213010, Руководство пользователя

Страница: 11 / 20

30L/38L SILENT OIL FREE AIR COMPRESSOR ENG
OPERATING INSTRUCTIONS
Note: Before using the air compressor, read the instruction manual carefully.
1. Intended use
This air compressor is intended for operation paint sprayers, air tools, grease gun, airbrusher, caulking
guns, sandblasters, inflating tires and plastic toys, spraying weed killer and insecticides etc. An air
pressure regulator is usually necessary for most of these applications.
2. General description of operation
To compress air, the pistons move up and down in the cylinder. On the down stroke, air is drawn in
though the valve inlet. The discharge valve remains closed. On the up stroke, air is compressed. The
inlet close and compressed air is forced out through the discharge valve, through the check valve and
into air receiver. Work air is not available until the air compressor has the air receiver pressure above
that required at the air service connection. The air inlet filter openings must be kept clear of
obstructions, which could reduce air delivery of the air compressor.
3. Working environment
Under comparative dry environment, the environment temperature should be between 0
0
C and +40
0
C,
avoid working in the sun or rain, avoid working in the environment where there is much dust or
corrosive gas.
Note: Always operate the air compressor in well-ventilated areas free of gasoline or other combustible
vapors. If the air compressor is being used to operate a sprayer do not place near the spray area.
4.Power requirements
This air compressor is designed to operate on a properly grounded 110-120V 60Hz or 220-240V 50Hz,
single-phase alternating current (AC) power source.
Warning: This product must be grounded. In the event of an electrical short circuit,
grounding reduces the risk of electric shock by providing an escape wire for the electric current.
This product is equipped with a cable having a grounding wire with an appropriate grounding
plug. The plug must be inserted into an outlet that is properly installed and grounded in
accordance with all local codes and ordinances.
5. Installation and location of the air compressor
Locate the air compressor in a clean, dry and well ventilated area. The air compressor should be
located at least 0.3m away from the wall or other obstructions that will interfere with the flow of air.
Place the air compressor on a firm level surface. The air compressor is designed with heat dissipation
fins that allow for proper cooling. Keep the fins and other parts that collect dust or dirt clean. A clean air
compressor runs cooler and provides longer service. Do not place rags, or other containers on top of
the air compressor or near these openings. Installation air filter (See Fig 1) and tank wheels on air
compressor before starting air compressor.
6. Before using your air compressor
Before first use of this air compressor or after the air compressor pump/motor has been replaced,
perform the following:
11