Vido WD010220750, Руководство по эксплуатации

Страница: 9 / 16

750W/850W IMPACT DRILL
ENG
9
OPERATING INSTRUCTIONS
NOTE: Before using the power tool, read the instruction manual carefully.
1. Intended use
The machine is intended for impact drilling in brick, concrete and stone as well as for drilling in
wood, metal and plastic. Machines with electronic control and right/left rotation are also suitable for
screwdriving and thread-cutting.
2. Before using your power tool
1) Be careful of hidden electrical lines or gas and water pipes. Check the working area, e.g., with a
metal detector.
2) Ensure that the power switch is in the off position. If the plug is connected to a power receptacle
while the power switch is in the on position, this power tool will start operating immediately, inviting
serious accident.
3. Installing and adjusting the auxiliary handle
To installing and adjusting the auxiliary handle, loosen the locking screw for handle collar in
anticlockwise direction. Slide the handle onto the power tool and rotate the handle around the
handle
position
direction to secure the handle . If you are left handed fit the handle the other way round.
Note: For your personal safety we recommend using the auxiliary handle at all times.
4. Inserting the tool into chuck
Remove chuck key from key storage tab at base of power tool handle, place key into chuck, turning
the key in anticlockwise direction to loosen chuck, inset tool and firmly tighten chuck by turning key
in clockwise direction (See Fig 2). Remove key and replace in storage tab at base of power tool
handle.
Warning: Before installing tool, remove mains plug from mains supply.
5. Installing the depth gauge
The depth gauge can be used to set a constant depth to drill. To use the depth gauge, loosen the
locking screw for depth gauge by rotating the auxiliary handle in anticlockwise direction. Insert the
depth gauge through hole in handle
6. Operating the on/off switch
1) To start the power tool, simply depress the switch trigger. The power tool speed is increased by
increasing pressure on the switch trigger. Release the switch trigger to stop your power tool.
2) If you wish to use the power tool continuously, depress switch trigger then lock on button, release
switch trigger first and lock on button second (See Fig 4). Your switch is now locked on for
continuous use. To turn off your power tool just depress and release the switch trigger. The switch
will return to "off" position automatically.
7. Variable speed control
until handle in desired
(See the
(See Fig 1)
clockwise
Tighten the locking screw in . collar the is the
Slide gauge to required depth and
tighten fully .
Fig 3) . depth