Vidikron Vision 70 Series Owner’s Operating Manual
A-1
PRE
L
IMINAR
Y
This Appendix describes how to personalize the ISF splash screen on the Vidikron Vision 70
Series DLP Projectors.
1.
Connect a PC to the Vision 70 RS-232 port and establish a serial connection; refer to
RS-232 Connection and Port Configuration
on page 67 if you need instructions.
2.
Press
MENU
on the projector remote control. Use the up- or down-arrow keys to
highlight
ISF Calibration
and press
ENTER
. Use the number buttons on the remote
control to enter the ISF Calibration menu passcode, then press
ENTER
again.
3.
Press
MENU
on the projector remote control. Then, select
Splash Screen Timer
from the
ISF Calibration menu.
4.
Use the left- or right-arrow buttons to set the Splash Screen Timer. This timer controls
how long the startup (Vidikron/ISF logo) image stays on-screen after you turn on the
projector. The range is from 5 to 60 seconds in 1-second increments. For this procedure,
set it to 30 seconds and press
EXIT
.
5.
In the HyperTerminal window, at the command prompt (>), type
U1
followed by the
customer name, four or five spaces and the ISF calibrator name:
6.
Press
<Enter>
.
7.
Press
MENU
on the projector remote control. Then, select
ISF Calibration
from the Main
menu.
8
.
Select
ISF Enable
from the ISF Calibration menu and set it to
On
.
Appendix A. Personalizing the ISF Splash Screen
on the Vision 70
Only ISF-trained and -certified technicians should attempt this
procedure!
Note
Содержание Model 70
