V-Tap ISDN PRI Manual EN v1.3 Okt 2018 © 2018 Vidicode 35
5.2
Enable DHCP temporary
When running with default settings, there is a way to enable DHCP
temporary. Then the settings page can be reached through the web
interface and DHCP can be set permanently or a fixed IP address can be
defined. If no settings are done, then DHCP is disabled again after reset.
•
Press the button: All LED's are ON.
•
Hold pressed for 1 second.
•
Release the button: Red, Green and Blue
LED’s flash 3 ti
mes
•
After about 2 seconds Red, Green and Blue flash again if an IP
address is assigned by the DHCP server.
•
The V-
Tap can show the IP address with the LED’s, see below.
•
Or the IP address must be obtained with some network tool.
•
The web page is now reachable on this IP address.
5.3
Show IP address
The IP address of the V-Tap unit can get lost for some reason or is
unknown because a DHCP server is used. In other words, the user cannot
reach the web interface anymore. There is a way to reset all settings to
factory values (see further), after which the IP address is on default
again. If that is not desirable, then there is a way to show the IP address
with the LED’s
:
•
Press the button: All LED's are ON.
•
Hold pressed for 5 seconds: All LED's go OFF.
•
Release the button: Only the Green LED goes ON.
•
Press the button now and the first digit is shown:
Green LED goes OFF,
Red LED blinks the first decimal digit (count!),
Green LED goes ON when finished.
•
Repeat pressing the button for the next digits. For example:
“192.168.0.10” needs the button to be pressed 12 times.
•
The Blue LED blinks once to show there is a dot in the address.
•
When no Green or Blue is blinking at all in between Green going
OFF-ON, it means the zero digit.
•
After the last digit, the system waits 5 seconds and then continues
normal operation.
