V-Tap ISDN PRI Manual EN v1.3 Okt 2018 © 2018 Vidicode 28
3.3.11
App Special Flags
App Special Flags
This parameter represents a mixture of internal options and/or
commands. When filled in as a numeric value, the used bits are all
on/off switches as shown below. The result of the sum of the used
bits must be entered as a decimal number. For example, setting both
bit3 and bit12 results in the value 8+4096 = 4104.
bit0 (+1) : Disable Auto Delete function when SD card is almost full.
bit1 (+2) : Enable SD Power Save Mode (slow clock during idle time).
bit2 (+4) : Disable initializing the IP-stack instead of Tunnel Close.
bit3 (+8) : unused
bit4 (+16) : Force Half Duplex on the LAN port.
bit5 (+32) : Force 10 Mbps on the LAN port.
bit6 (+64) : Set time as Daylight Saving Time.
bit7 (+128) : Disable Daylight Saving Time Correction in the NTP function.
bit8 (+256) : Flash Overclocking (not safe to do).
bit9 (+512) : Disable CPU Cash Controller (system much slower).
bit10 (+1024) : Disable Memory Protect Unit (not safe to do).
bit11 (+2048) : Disable USB function, so no HID recognition (saves power).
bit12 (+4096) : Disable USB sleep function 10 minutes after start-up.
The App Special Flags field can also be used to enter commands for extra
settings and features (most of them are preceded by a dot):
"FACTORY" = Factory settings! The IP address is back on 192.168.55.66.
"FACTORY WIFI" = Factory settings AND enable Wi-Fi module & settings.
"FACTORY NOWIFI" = Factory settings AND disable Wi-Fi module & settings.
Extra ISDN & Recording settings:
".II
”
= Disable recording of Incoming calls.
".IR"
= Record audio of Remote side only.
".IN"
= Disable connected number for the number-list.
".IM"
= Disable remote number for the number-list.
".IV"
= Reversed IN<>OUT line operation.
".IF"
= Enable Frame transmission with In-Line mode.
".IX"
= Alternative Pass-Through method.
".IC"
= Disable CRC-4 Multi-frame on the ISDN-E1 line.
".IA<num>
= Transmitter Amplification 1-255 (default 100).
".IS<num>
= Receiver Sensitivity 1-255 (default 96). 1024 enables AGC.
".IB<sec>"
= Notification Beep interval in seconds, using "NBEEP.WAV".