66250675-EN - V1.0 - 05/09/17
35
4000 Series Vandal Resistant GSM - Technical Manual
4000 Series Vandal Resistant GSM Audio Intercom with Proximity Facility
4000 Series Back Box Installation
INSTALLING A SURFACE MOUNT DOOR STATION
1. Place the surface box against the wall (165-170cm between the top of the box and the floor level as shown in
Fig.47
) and mark
the fixing holes
for the wall plugs
and the hole for the cables
(Fig.48).
Observe the orientation of the surface box with
the hinge mount
on the left;
In order to prevent water ingress we highly recommend using a silicon sealant between the wall and the back box
,
ON THE LEFT, TOP AND RIGHT SIDES ONLY AND AROUND ALL THE HOLES
. DON'T USE SILICON SEALANT ON THE
BOTTOM SIDE OF THE BACK BOX (Fig.49);
2. As shown in
Fig.48,
drill the fixing holes
, insert the wall plugs
and feed the cables
through the surface box opening
, fix the surface box
to the wall using the screws
;
3. Next fit the neoprene seal
(removing the thin film first) along the top side of the module
,
as shown in
Fig.50;
4. Before installation of the module support frame
to the surface box
, fit the module
to the support frame
as shown
in
Fig. 51
then, as shown in
Fig.52,
fit the module fixing brackets
using the fixing screws
;
5. Next take the frame’s hinges
and hook the module support frame
to the surface box
, starting from the left following
the guide arrows, as shown in
Fig.53.
Ensure that the frame’s hinges
(Fig.53)
fit inside the relevant hinge mounts
inside the
surface box
, following the guide arrows, as shown in
Fig.54
;
6. Pull back the module support frame
from the surface box
while moving it slightly to the left, following the guide arrows,
as shown in
Fig.55
;
7. Next open the module support frame
and clip the hinge locks
to the hinge mounts
, following the guide arrows, as
shown in
Fig.56
;
8. Take the cable wires
and make the required wiring connections into the terminals
on the back of the module
, as
shown in
Fig.57
, using the screwdriver provided
(from
Fig.58
and using the flat blade end);
9. Make any other necessary panel adjustments required, fitting the SIM card and setting the dip-switches etc. For the button
module configuration refer to
Fig.3
and the button harness table on page 7 and for connecting the antenna refer to
Fig.7
on
page 9;
10. After the system has been tested and is working correctly, move back the module support frame
carefully and then fix it to the
surface box
using the screwdriver provided
(using the torx end) and the torx pin security screws provided
, as shown in
Fig.45
.
Note: do not over tighten the screws more than is necessary.
Note: if additional holes are made in the surface box, oxidation problems may appear unless the unprotected metal is
coated with a protective paint.
NOTES
• The screwdriver's blade has two sides, one flat and one torx, to select one of them unplug the blade from the screwdriver body
and plug it into the required side;
• The example shows the use of only one back box hole
for the wires, this is done to keep the file drawings clear. Naturally the
installer can use more than one back box hole if required.
