videotronic SN-15AH PPHS, Инструкция по монтажу и эксплуатации

Страница: 7 / 32

MOUNTING AND CONNECTING
-7-
Mounting the Camera Station
Attention When installing the camera station please make sure to follow the order
mentioned below.
1. Install the pan/tilt motor to a Videotronic WA-40BSN wall bracket using the
attached installation material (M6 x 20 hex / M6 nut/ M6 washer).
2. Fix the service junction box incl. power supply unit as near to the motor as
possible. The pre-wired connections of the motor have a length of 2,5 metres and
have to be connected to the service junction box after installation.
3. Fix the VI “System Camera” unit to the bracket of the motor using the attached
screws. The camera can also be mounted upside down, depending on the
application.
4. When connecting the system cable, see correct polarity of the cable (PIN 1 =
transparent). Further details are mentioned in the operating instructions of the
system camera. After having installed the system camera, please fix the lateral
covers to the bracket of the motor using 2 screws (M3 x 8).
26-pin system connector (camera connection)
1 10 zoom - 19 auto focus
2 heater - 11 focus + 20 shutter
3 lanc signal 12 focus - 21 PP +
4 linelock GND 13 GND 22 PP -
5 +12 V DC 14 backlight 23 zoom position
6 linelock 15 Y signal 24 focus position
7 GND 16 C signal 25 current loop
8 video 17 NC 26 current loop
9 zoom + 18 NC