MOUNTING AND CONNECTING
-15-
Pre-set call via alarm inputs (switch 12 / DIP I)
The P/T unit can also be controlled via control (alarm) inputs over the RS485 interface.
With these control inputs you can call pre-set camera positions from the memory. The
contact numbers of the control inputs (1-64) are directly assigned to the corresponding
position number (1-64).
If you want to transfer the alarm of a camera station to a connected VIDEOTRONIC
video matrix, switch 12 (DIP I) has to be set to position ON. The video matrix must have
the system address „00“ since only this address can process the alarm message of the
camera station. For further information, please ask for the corresponding operating
instructions.
switch 12
alarm message adr. 00
On
RS-485 active
Off
RS-485 not active
Change from (F)BAS to Y/C operation (switch 5 and 6 /DIP II)
F(BAS) mode
Y/C mode
switch 5
On
Off
switch 6
Off
On
switch 7
On
Off
switch 8
Off
On
Activating current loop / RTS, CTS (RS-232)
current loop / RTS, CTS (RS-232)
active
not active
switch 9
Off
On
switch 10
Off
On
switch 11
Off
On
switch 12
Off
On
When supplied from the factory, current loop and RTS, CTS of the RS-232 interface are
not active (switch 9 -1 2 at position OFF).
Содержание SN-15AH PPHS
Страница 2: ...1...
Страница 8: ...MOUNTING AND CONNECTING 8 Connecting the Telemetry Receiver...
