Videotec SR4C, Руководство по эксплуатации

Страница: 35 / 98

5.1.1 Installing/wiring the disk
Attach the hard disk/s to the holes on the base of the device (see fig. 1).
The hard disk is wired up just like a normal personal computer: the flat cable supplied is
connected to the electronics board of the DVR at one end (blue connector), and has two
other connectors: the master (the black connector at the other end of the cable) and the
slave (the grey connector about half way along the cable). If the hard disk is installed on the
master connector it will be considered the primary disk and vice versa will be considered the
secondary disk if it is connected with the slave connector. For the correct wiring, see fig. 2.
Warning: before connecting the disk check its handbook for the correct position of
the jumpers (master or slave configuration); otherwise the recording functions will
not work
For the maximum capacity of the hard disk, see the technical specifications for the
product.
After connecting the flat cable, in each hard disk insert the power supply cable of the disk
itself (this is identical to the cable for a PC) and close up the appliance.
Switch on the DVR and make sure it recognises the primary (and secondary) disk/s correctly
(master and slave).
Page 7 of 22 MNVC4SRC_0648