Videoswitch Vi-K2, Руководство пользователя

Страница: 13 / 107

Vi-K2/Vi-K3 Universal
Keyboard
Vi-K2 Universal Keyboard User Manual
11
2 Vi-K2 Configuration
2.1 Quick Configuration
This section describes how to set-up the Vi-K2 for use with any one type of dome. For more complex
configurations, see section 2.2.
•
Holding the
ALT
key on, press the
CONFIG
key.
•
The LED display will show “
PSd
”, indicating that a password must be entered.
•
Press the number keys
1
,
2
,
3
,
4
,
5
,
6
(to enter default password).
•
Press the
OK
key (the characters “
C1.1
” should be flashing on the display).
•
Press the
DOME
key (the display shows “
1.01
” indicating “
DOMES-1
” output has been assigned
protocol number
1
)
•
Enter the protocol you require by pressing two number keys (refer to section Error! Reference
source not found. ). E.g.
1
followed by
2
would select Borsatec (protocol 12).
•
Holding the
ALT
key on, press the
CONFIG
key. The word “
Sto
” indicates that the configuration is
being stored.
The Vi-K2/Vi-K3 is now ready to control all domes connected to the “
DOMES-1
” output and a Digital
Recorder connected to the “
Out
” output.
Note
•
If the Vi-K2/Vi-K3 is being used as a slave keyboard, no further configuration is required after factory
reset.
•
Each dome must be set-up with a camera address (usually DIP switches on the dome).
•
The Digital Recorder must have its default unit address (i.e. “001”).
2.2 Full Configuration
2.2.1 Restore Factory Configuration
If you wish to return all settings to the factory defaults, follow this procedure:
•
Power on the Vi-K2 while pressing the
ALT
key. Keep pressing the
ALT
key (for about 10 seconds)
until the word “
Fac
” is displayed on the LED display.
•
The Vi-K2 now has all factory settings restored.
2.2.2 Entering Configuration Mode
The Vi-K2/Vi-K3 has a
Configuration Mode
that is allows you to specify the dome protocols and change
the user password. To enter this mode, follow these steps:
•
Holding the
ALT
key on, press the
CONFIG
key.
•
The LED display will show “
PSd
”, indicating that a password must be entered.