11
.
The keypad will display ‘CODE/STATE
MODIFICATION?’.
If you would like any other events to be
transmitted, press the YES key.
Press the ESC/NO key to accept the default.
Manually Enable/Disable events that are
reported:
CONFIGURATION > CONFIGURATION
MONITOR.STATION > ALARM CODES > TRANS.
STATE MODIFICATION >
select which events to
be transmitted:
Alarm – Only Appearance is transmitted
Alarm/End – Both Appearance and Restoral sent
Not Transmitted – Not Transmitted
12
.
Use the keypad to name the area 1. Leave blank
for default (Area 1) and press the YES key to
confirm.
Repeat the same step for the remaining areas.
13
.
Choose the arming option depending on the
configurations.
FROM THE HOST:
The XT Panel will be on
XTender mode that arm/disarm off the latching
9-12V on the arming input.
STANDALONE:
The XT Panel will be a single
system. Arm/disarm will be controlled by
Videofied devices (Wireless keypad, remote
control etc).
Press the YES key to continue.
*If you selected ‘FROM THE HOST’, please skip
to step 15.
The default transmitted
events:
Intrusions Panic. Periodic
Test, Tamper, Supervision
Fault, Device Battery Low.
Panel Battery Low.
Содержание XT200i
Страница 5: ......
