Last
update:
2016-02-24
11:46
system_integration:hub4_grid_parallel https://www.victronenergy.com/live/system_integration:hub4_grid_parallel?rev=1456310763
https://www.victronenergy.com/live/
Printed on 2020-12-11 00:44
Press right until 'End' appears.
6.
Press down. The display now shows measurements again.
7.
On a single phase setup, you can use a single AC sensor to measure both grid and PV inverter. For
wiring see the diagram below.
On the CCGX go to the grid meter in the Wired AC sensor settings. Make sure 'Phase type' is set to
'Single phase' and 'PV inverter on phase 2' is enabled.
9. FAQ
What happens when the Multi does not receive data from the CCGX / Wired AC Sensor?
It will switch to Bypass, and Sustain mode is still active and will prevent the battery from being
discharged below, approximately, 50%. See Paragraph 6 for the details on Sustain and the Sustain
Voltages.
Is there a winter mode, like in Hub-2?
