Victron energy Blue Power BMV-602, Руководство пользователя

Страница: 12 / 24

8
operating in the ‘float’ stage, the charger considers the battery full. At
this moment the BMV must also determine that the battery is full. Now
the Amp hour count can be reset to zero and the state-of-charge
reading can be set to 100.0%. By precisely adjusting the charged-
parameters in the BMV, the battery monitor can automatically
synchronize with the charger when the ‘float’ stage is reached. The
range of the charged parameters is wide enough to adjust the BMV to
most battery charging methods.
When the voltage supply to the BMV has been interrupted, the
battery monitor must be resynchronized before it can operate
correctly.
Please note that regularly (at least once per month) fully charging your
battery not only keeps it in sync with the BMV, but also prevents
substantial capacity loss of your battery which limits it’s lifetime.
2.4 Using the menus
There are four buttons that control the BMV. The functions of the
buttons vary depending on which mode the BMV is in. When power is
applied, the BMV starts in normal mode.
Button Function
Normal mode
Setup mode
Setup
Hold for 3 seconds to
switch to setup mode -When not editing, hold this button for 3 seconds to switch
to normal mode.
-When editing, press this button to confirm the change.
When a parameter is confirmed, it will be checked for
validity. If the value is valid it is stored. If the value is
invalid, the display blinks 10 times and the nearest valid
value is displayed but not stored. The value can be
corrected if needed, and can then be stored by pressing
this button again.
Select
Switch between the
monitoring and historical
menus. -When not editing, press this button to begin editing the
current parameter.
-When editing, this button will advance the cursor to the
next editable digit.
+
Move up one item. -When not editing, this button moves up to the previous
menu item.
-When editing, this button will increment the value of the
selected digit.
-
Move down one item. -When not editing, this button moves down to the next
menu item.
-When editing, this button will decrement the value of the
selected digit.