3. Press the PROGRAM/PAIR BUTTON once, the LED DISPLAY will flash "00"
on the LED DISPLAY.
4. Press PREV BUTTON or NEXT BUTTON until the desired track number is
reached.
5. Press the PROGRAM/PAIR BUTTON
again
to store the selection.
6. Repeat the (4) to (5) steps until you have entered all the tracks you want to
program.
7. To play the stored sequence, press the PLAY/PAUSE BUTTON.
8. After all the stored tracks have been played the CD will automatically stop.
NOTES:
•
When 20 tracks of CD music have been programmed, the memory is full and
“FUL” will be indicated on the LED DISPLAY.
•
If you want to cancel the program memory, you need to disconnect the
power adaptor from the unit.
•
The Repeat function also applies to programmed playback.
To repeat programmed tracks:
1. During program play, press REPEAT BUTTON once will repeat the
specifically programmed tracks.
2. Press the REPEAT BUTTON again to repeat all the programmed tracks.
AUXILIARY INPUT
Use the AUX-IN JACK to connect external audio devices like MP3 players, CD
players and the older, non-dockable iPod (except iPod shuffle 3
rd
generation)
to listen through the speakers of this system.
1. Use a 3.5mm Aux-in cable (not included) to plug one end into the AUX-IN
JACK at the rear of the unit and the other end of the cable into the Line-out
Jack or Headphone Jack of your external audio device.
2. Turn on the VTA-60 and your external audio device.
3. Press the MODE BUTTON to Aux-in mode, the LED DISPLAY will
indicate “AU”.
4. The volume level can be controlled through the main unit.
Operate all other functions on the external device as usual.
RCA OUTPUT
For amplifier device with RCA auxiliary input sockets, insert the white and red
plugs on the RCA cable (not included) into the unit. Insert the opposite end into
the amplifier device. Be sure to connect the white plug to the white jack and the
red plug to the red jack.
