User Manual for DRS Refrigerators
Victory
Rev. 12/20
Victory
8
UNPACKING AND SET UP
CAUTION
Carefully inspect the shipping carton for damage. This is the only time that shipping damage may be claimed. If damage is
suspected, open the carton immediately and, if there is damage, retain the carton and contact the shipper to make a claim.
Do NOT contact the manufacturer.
Uncrating
Tools Needed: ¾" box wrench, adjustable wrench, level, flat
head screw driver, and box cutter.
1. Remove the cardboard top capping, all clear tape,
and all staples including those at the bottom of the
cardboard carton and skid.
2. Start from the top of the carton. Using the box cutter,
carefully make one continuous cut to the bottom of the
skid. Remove cardboard carton and discard.
3. Move unit as close to final position as possible before
removing the skid.
Note: The skid must be removed before the casters or legs
can be attached.
Do NOT tip unit on its front or sides. If tipped onto the back,
unit must not be started for 3 hours.
Note: additional clear plastic protective wrap is applied
directly to any product with a glass door.
Skid Removal and Leg Attachment
Tip the unit forward and remove the skid.
1. Remove the shipping bolts using the ¾" box wrench
while cabinet is held in one direction. Repeat the
process while the cabinet is held in the opposite
direction.
2. Tilt the cabinet in one direction approximately 8" and
block it securely with pieces of 2x4 lumber or other
suitable material.
Note for the following: None of the threads on the leg or
caster stem should be visible once screwed in.
3. Thread the stem casters or legs into the ½ -13 holes in
the bottom of the cabinet. Tighten by hand as much
as possible. Some models may already have levelers
installed. If so, then the levelers will need to first be
removed and discarded.
4. Once the caster or leg cannot be turned any further,
use a 3/4 inch wrench to tighten the nut in between the
mounting plate and the wheel of the caster until snug.
5. Repeat this procedure with unit secured in the opposite
direction so as to access the remaining legs/casters/
levelers
6. If plate casters or legs are installed instead of stem
casters or legs, then repeat step 3 above and secure
the plate with either #14 AB screws, or ¼-20 screws,
depending upon which are required.
7. If levelers are employed, then repeat step 3 above and
thread the leveler in place. Then repeat step 5.
Leveling
Cabinets must be leveled when installed. Level should be
measured on the headrail.
Failure to level your cabinet may result in door not sealing,
closing correctly, or condensed water not draining properly.
For cabinets with legs, rotate the foot of the leg with an
adjustable wrench to achieve desired height for leveling.
For cabinets with casters, level by placing large washers in
between the ½' stud and the holes in the bottom of the case.
Do NOT loosen casters to level the
cabinet. Casters MUST be tightly
secured to cabinet for full strength.
Install or attach any accessories that will be used Remove
any plastic covering the stainless steel.
Risk of personal injury.
Unit must be securely supported
while attaching casters or legs.
WARNING
