Victory BX32, Руководство оператора

Страница: 30 / 64

2 . Deflector Position:
Each discharge hood is equipped with a
deflector on the end to place the chips
exactly where desired. There are 2 types
available:
a. Manual Clamp (BX42):
The deflector is held in place by clamp-
ing bolts on each side. Loosen the
clamps, move the deflector and tighten
the clamps. Position as desired.
b. Spring-Loaded (BX62):
The deflector is spring-loaded up and
held in place by a chain. Release the
chain from its anchor bracket and move
the deflector to its desired posi-tion.
Secure chain in its anchor bracket.
3. PTO Control:
If you are not familiar with the location of the
PTO control on your tractor, review your
tractor's Operator's Manual. Always engage
the PTO control slowly when the engine is
running at low idle RPM. Disen-gage the
PTO control slowly at low RPM to allow the
machine to slow and stop before engaging
the PTO brake. Remember the PTO drives
the rotor. When the PTO is engaged the
rotor will also start to turn.
4. Flow Control Valve:
This manually-set flow divider allows the
operator to set the flow through the cir-cuit
from 0% to 100% by dumping the excess
flow back to the tractor. A scale on the
face of the valve is numbered from 0 to 10
to define the percent of flow from 0 to
100% flowing into the circuit. The
hydraulic feed circuit is equipped with a
flow divider so the operator can adjust the
feeding speed appropriate for the operat-
ing conditions. Loosen the lock and move
the pointer arm to the desired position.
Tighten the lock bolt. Adjust in small incre-
ments as a small change can result in a
large change to feeding speed.
Manual Clamp
Spring-Loaded
Fig. 21
DEFLEC
TOR POSITION
Fig. 22 FLOW CONTROL VALVE