Victory Motorcycles 2011 Cross Country, Руководство пользователя для мотоциклиста

Страница: 41 / 126

37
Pre-Ride Inspections
Turn the ignition key to the ON position and move the stop/run switch to RUN before per-
forming the following electrical inspections. Return the ignition key to the OFF position
after completing these inspections. If inspection of any electrical item reveals component
failure, repair or replace the component before operating the motorcycle.
Item Inspection Procedure
Electrical
Headlamp Switch to high beam. Verify that the high beam indicator comes on and that
lamp brightness increases.
Taillight/Brakelight Verify that the taillight and license plate light illuminate. Verify that the taillight
lamps increase in brightness when the front brake lever is applied and also
when the rear brake pedal is applied.
Turn Signals Move the turn signal switch to the left. Verify that front and rear left turn signals
flash, as well as the corresponding light on the indicator panel. Push the switch
inward to cancel the signal. Verify that the signals and the indicator light stop
flashing. Repeat the procedure for the right turn signals.
Emergency
Flashers Press the top of the hazard switch to turn the flashers on. Verify that all four turn
signals flash, as well as the lamps on the indicator panel. Turn the flashers off.
Verify that all signals and indicator lamps stop flashing.
Horn Press the horn button. Verify that the horn sounds loudly.
Neutral Indicator Place the transmission in neutral. Verify that the neutral indicator lamp illumi-
nates and that the letter “N” displays in the gear position display.
Low Oil Pressure
Indicator Verify that the low oil pressure lamp illuminates. Start the engine and verify that
the low oil pressure lamp goes off.
Engine Stop/Run
Switch Start the engine. Move the stop/run switch to the STOP position. Verify that the
engine stops. Attempt to restart the engine to verify that the engine WILL NOT
start.
General
Engine Oil Level Check the oil level on the dipstick.
Fuel Level View the fuel gauge or information bar.
Tires Inspect condition, pressure and tread depth.
Brake Operation Inspect pedal and lever movement.
Brake Fluid Levels Check front and rear brake fluid levels.
Brake Components Inspect hoses, connections, brake pads.
Throttle Inspect hand grip and throttle freeplay.
Clutch (Mechanical) Check lever operation and freeplay.
Front Suspension Check for leaks, debris and damage.
Steering Check for smooth operation.
Rear Suspension Check shock movement and air pressure, verify ground clearance.
Drive Belt Check for wear, damage, proper deflection.
Sidestand Verify smooth operation, inspect pivot bolt, spring and pad.
Fasteners Inspect for loose, damaged or missing fasteners.
Mirrors Adjust for proper rear view.