Victoria-05 Ltd.
12
10.2.1. Main user control panel.
To visualize every function from the display it is necessary to touch the respective icon. The blue arrow in the sub menu is for
returning to the previous screen. By pressing
SAVE
all corrections are saved. The left and right arrows are for decreasing and
increasing the value of the respective parameter.
Display symbol
Description
00/00/0
Date display
Day/ Month/ Year
00 : 00
Hour display
Hour : Minutes
Indoor temperature
The number in the rectangle denotes the current (momentary) indoor temperature. The number
in the circle denotes the temperature, one has set to
maintain in the room.
We would like to maintain 25 degree in the room –
how shall we set this?
One has to touch the icon with the number of the
indoor temperature. An additional page would
open, where one can set the temperature, they
would like to.
Major Specific Features:
- the min. possible temperature allowed is 2°С;
- the max possible temperature allowed to set is 45°С.
Entering the temperature is done through the Left and / or Right icons. Saving the value is done
with the Button .
Pressing the button displays a green ribbon low down, which one should wait to fill up, and then
it would disappear, in this case one can sure that the value has been saved correctly! Just in
case, during the time of saving, access to the Back Icon is denied to prevent involuntary
interruption of the save process. The latter would reappear after the process has finished.
Water Heater Temperature.
User Settings
The number in the rectangle denotes the current (momentary) temperature within the water
heater. The number in the circle denotes the temperature, one has set to maintain within the
water heater.
We would like to maintain 55 degg in the water heater. How shall we set this?
One has to touch the icon with the number of the water heater. An additional page would open,
where one can set the turn-off temperature, they would like to, as well as how much it should
go down with to restart once again!
Manual feeding
Pressing the icon would start the screw conveyor for 10 seconds! When this time is over, the
screw conveyor stops again and waits until a new icon click is done.
The icon would only be visible in Ready Mode, whereas, respectively, on starting of the fireplace
it will disappear!
Main menu and
service settings
When the icon is touched, a new page with the main menu is opened.
10.2.2.Types of modes of the control unit.
Ready mode
Modulation 4
Start
Modulation 3
Fuel Mode
Modulation 2
Ignition
Modulation 1
Burning
Clean Mode
Modulation 5
ECO mode
