10
VE46 Pipe Roll Grooving Tool
4.
Install the power drive mounting plate
onto the tool by placing the smaller cutout of
the mounting plate toward the drive shaft/
drive-adapter assembly and the larger cutout
toward the drive nut, as shown above.
5.
Insert a hex-head cap screw into a hole
in the mounting plate and tool body. Install a
lock washer onto the end of the hex-head cap
screw, and thread a hex nut onto the end of
the hex-head cap screw. Repeat this proce-
dure with the other hole in the mounting plate
and tool body.
5a.
Tighten the two hex nuts to secure the
mounting plate to the tool body.
POWER DRIVE SETUP
The VE46 tool is intended for field or shop set-
up and can be attached to a Victaulic VPD752
Power Drive or a Ridgid 300 Power Drive with
a 38-rpm maximum chuck speed. The power
drive kit, which includes a special power drive
mounting plate and hardware, must be
ordered from the Victaulic Tool Company.
1.
Remove all components from the pack-
aging, and make sure all necessary items are
included. Refer to the "Receiving the Tool"
section on page 5.
2.
Select a location for the power drive,
tool, and pipe stand by taking into consider-
ation the following factors (refer to the draw-
ings below for overall dimensions):
2a.
The required power supply (Refer to the
power drive manufacturer’s instructions)
2b.
Adequate space to handle pipe lengths
2c.
A firm and level surface for the power
drive, tool, and pipe stand
WARNING
• DO NOT plug the power drive into the electrical
source until instructed otherwise.
Accidental startup of the tool could result in serious
personal injury.
Dimensions – inches (millimeters)
A
B
C
D
45.00
43.00
37.00
41.00
(1143,0)
(1092,2)
(939,8)
(1041,4)
A D
C
B
TM-VE46 1924 Rev_B.fm Page 10 Wednesday, January 19, 2005 8:59 AM
