VE106 Groove-N-Go Tool
3
18.
Do not over-reach.
Maintain proper
footing and balance at all times. Make sure
the safety foot switch is easily accessible for
the operator.
19.
Do not force the tool.
Do not force the
tool or accessories to perform any functions
beyond their capabilities. Do not overload the
tool.
20.
Do not abuse the safety foot switch
cord.
Never yank the cord out of the recepta-
cle. Keep the cord away from heat, oil, and
sharp objects.
21.
Disconnect the power cord from the
electrical source before servicing the tool.
Only authorized personnel should attempt to
perform maintenance on the tool. Always dis-
connect the power cord from the electrical
source before servicing or adjusting the tool.
22.
Maintain tools with care.
Keep tools
clean at all times to ensure proper and safe
performance. Follow the instructions for lubri-
cating tool components.
23.
When tools are not in use, store them
in a dry, secure place.
24.
Use only Victaulic replacement parts
and accessories.
Use of any other parts may
result in a voided warranty, improper opera-
tion, and hazardous situations. Refer to the
“Parts Ordering Information” and “Accesso-
ries” sections on page 25.
25.
Do not remove any labels from the
tool.
Replace any damaged or worn labels.
INTRODUCTION
The Victaulic VE106 Groove-N-Go tool is a
very portable, semi-automated, manual-feed
tool for roll grooving pipe/tubing to receive
Victaulic grooved pipe/tubing products. The
standard VE106 Groove-N-Go tool is supplied
with grooving rolls for 1
1
/
4
- 6-inch carbon
steel pipe. Rolls are marked with the size and
part number, and they are color coded to
identify the pipe material. For roll grooving to
other Victaulic specifications and materials,
refer to the "Tool Rating and Roll Selection"
section on page 28. Grooving rolls for other
specifications, sizes, and materials must be
purchased separately.
RECEIVING THE TOOL
VE106 Groove-N-Go tools are packed individ-
ually in sturdy containers. Upon receipt of the
tool, make sure all necessary parts are includ-
ed. If any parts are missing, contact the Vic-
taulic Tool Company.
NOTICE
• Drawings and/or pictures in this manual may be
exaggerated for clarity.
• The tool, along with this operating and maintenance
instructions manual, contains trademarks, copy-
rights, and/or patented features that are the exclu-
sive property of Victaulic Company.
CAUTION
• This tool must be used ONLY for roll grooving pipe/
tubing designated in the “Tool Rating and Roll
Selection” section of this manual.
Failure to follow this instruction could overload the
tool, resulting in reduced tool life and/or damage to
the tool.
TM-VE106 3736 Rev_B.fm Page 3 Monday, May 9, 2005 12:02 PM
