VE106 Groove-N-Go Tool
7
4.
Remove the legs from the leg storage
tubes. Install the two front legs by inserting
them into the sockets located on the under-
side of the tool head table. Make sure each
leg seats properly in the sockets. Rotate the
legs so that each foot points away from the
tool. Using a
1
/
2
-inch wrench, tighten each
5
/
16
– 18 hex bolt to secure the legs to the tool.
5.
Make sure the front legs are securely
fastened in the sockets. Lift/tilt the tool into the
vertical (upright) position, as shown above.
6.
With the tool in the vertical (upright) posi-
tion, install the third leg into the socket adja-
cent to the drive motor. Rotate the leg so that
the foot points away from the tool. Using a
1
/
2
-
inch wrench, tighten the
5
/
16
– 18 hex bolt to
secure the leg to the tool.
7.
Level the tool from front to back.
NOTE:
The top of the tool head table is a good loca-
tion to measure “level,” as shown above. If the
tool is not level, proceed with 7a.
TM-VE106 3736 Rev_B.fm Page 7 Monday, May 9, 2005 12:02 PM
