3 | 028-0485-00
November 2017
I
NSTALLATION
Remove security screw on bottom of Room
Controller cover.
▪
Open unit by pulling on bottom side of
Room Controller (fig. 1).
▪
Remove wiring terminals from sticker.
▪
Read FCC ID and IC label installed in
the cover.
Location
1.
Do not install on outside wall.
2.
Do not install in areas exposed to direct
heat source.
3.
Do not install near an air discharge
grill.
4.
Do not install in areas exposed to
direct sunlight
5.
Do not install in areas that restrict
vertical air circulation to Room
Controller.
Installation
1.
Swing open Room Controller PCB to
left by pressing PCB locking tabs (fig.
2).
2.
Pull out ca
bles 6” out from the wall.
Ensure wall surface is flat and clean.
3.
Insert cable in central hole of base.
4.
Align base and mark location of two
mounting holes on wall. Install proper
side of base up.
5.
Install anchors in wall.
6.
Insert screws in mounting holes on
each side of base (fig. 2).
7.
Gently swing back circuit board on
base and push until the tabs lock.
8.
Strip each wire 1/4 inch from end.
9.
Insert each wire according to wiring
diagram.
10. Gently push excess wiring back into
hole (fig. 3).
11. Re-Install wiring terminals in their
correct locations (fig. 3).
12. Re-install cover (top side first) and
gently push extra wire length back into
hole in wall.
13. Install security screw.
