Vicon XX123-00-02, Руководство по установке и эксплуатации

Страница: 14 / 26

6
••
Installation XX123-00-02 Rev 203 Network Interface
When an invalid address is used a “Request timed out” message appears. See screen below.
Connections
After the IP installation is successfully completed, unplug the power cord to power off the unit. Disconnect the
Installer Cable. Refer to Connection for Operation diagrams in Quick Installation section.
1. Connect the supplied 12 VDC power cord to the AURC-NIU.
2. Connect a coaxial cable from the Video IN BNC connector on the AURC-NIU to the CVBS video output BNC
connector on the AurorAcorD.
3. Connect a coaxial cable from the Video OUT BNC connector on the AURC-NIU to the Video IN connector on
any CCTV monitor.
4. Connect the supplied Remote Control Cable (part number 1298-5244-01) to the SERIAL port of the AURC-
NIU and one of the AurorAcorD COM ports. Use only the supplied cable.
Note: Refer to the AurorAcorD manual (XX091) for information on settings for the COM port for serial (RS-232)
configuration. The serial port should be set to 9600, 8, none/1. To communicate with a receiver for PTZ
control, use COM 2; for communication with a host PC, use COM 1. The PC port settings must match
the settings on the AururAcorD.
5. If the NIU is to stay connected to one PC (standalone), leave the Ethernet connection as is; if it is going to
be connected to a network switch or HUB, disconnect the Ethernet connection to the PC and connect a
standard (non-crossover) Cat5e cable from the Ethernet port on the AURC-NIU to the Ethernet port on the
HUB/switch.