8
Step 3: Adjust the camera angle
Loosen the angle adjustment screw, adjust the camera angle and direction to the desired position and then
tighten the screws.
Adjust the Camera Angle
The camera installation is complete.
Connections
Connecting to the RJ-45
Connect a standard RJ-45 cable to the network port of the network camera. Generally a cross-over cable is used
for direct connection to PC, while a direct cable is used for connection to a hub. You can also use a router
featuring PoE (Power over Ethernet) to supply power to the camera.
•
Connecting Alarms
There are two dry contact alarm inputs and one alarm output provided; the alarm output acts as a switch to
drive an external device, such as a light. Refer to the figures below for connection and utilization of alarm
input/output. Be sure to follow the current limits noted in the diagrams.
•
Connecting the Power
Connect the power for the network camera, 24 VAC or 12 VDC. For 12 VDC, connect the positive (+) pole to the
‘+’ position and the negative (-) pole to the ‘-’ position for the DC power.
–
Be careful not to reverse the polarity when connecting a 12 VDC power cable.
–
A router featuring PoE (Power over Ethernet) can also be used to supply power to the camera.
•
Connecting Audio
Connect Speaker to Audio line output and external Mic to Audio input line.
