V923-N Quick Installation Guide
• ID and IP assignment
To make changes in the OSD menu, the optional OSD controller (V920D-OSD) can be used to set
the camera title and IP address.
1.
Connect the OSD Controller to the Service Monitor port of the network camera.
2.
Connect Service Monitor and the Video Output port of the OSD Controller.
3.
Press the SET button on the controller to access the Main Menu.
4.
Change camera ID and IP address as needed. Additionally, the Name (or title) of the camera
can be changed. Use the
↑↓←→
buttons on the controller to change the parameters.
5.
Select SAVE or CANCEL to exit the Main Menu.
The Video Output can also be used for easy zoom and focus control when adjusting the lens.
Video Output is restricted to 704x480 (576) resolution.
Note:
The optional V920D-OSD OSD Controller can be purchased separately.
2.3 Network Connection and IP assignment
The network camera is designed for use on an Ethernet network and requires an IP address for
access. Most networks today have a DHCP server that automatically assigns IP addresses to
connected devices. By the factory default, your camera is set to obtain the IP address automatically
via DHCP server. If your network does not have a DHCP server the network camera will use
192.168.1.100 as the default IP address.
If DHCP is enabled and the product cannot be accessed, run the “Smart Manager” utility on the CD to
search and allocate an IP address to your products, or reset the product to the factory default settings
and then perform the installation again.
1. Connect the network camera/device to the network and power up.
2. Start SmartManager utility (All Programs>SmartManager>SmartManager), the main window will
be displayed, after a short while any network devices connected to the network will be displayed
in the list.
5
