Vicon V922B-W551-A1, Быстрое руководство

Страница: 7 / 20

7
2.2 Connections
⚫ Micro SD memory slot
Remove the rear cap of the camera to insert the SD memory card.
⚫ Connecting to the RJ-45
Connect a standard RJ-45 cable to the network port of the network camera. Generally a cross-over cable
is used for direct connection to PC, while a direct cable is used for connection to a hub.
You can also use a router featuring PoE (Power over Ethernet) to supply power to the camera.
⚫ Connecting Alarms
AI (Alarm In):
You can use external devices to signal the network camera to react on events.
Mechanical or electrical switches can be wired to the AI (Alarm In) and G (Ground) connectors.
G (Ground):
Connect the ground side of the alarm input and/or alarm output to the G (Ground)
connector.
AO (Alarm Out):
The network camera can activate external devices such as buzzers or lights.
Connect the device to the AO (Alarm Out) and G (Ground) connectors.
⚫ Connecting the Power
Connect the power of 12 VDC for the network camera. Connect the positive (+) pole to the ‘+’ position
and the negative (- ) pole to the ‘ - ’ position for th e DC power.
– Be careful not to reverse the polarity when connecting the power cable.
– A router featuring PoE+ (Power over Ethernet) can also be used to supply power to the camera.
– For the power specifications, refer to the Appendix, Product Specification.
– Power for PoE+ switch must be turned off if using 12 VDC.
⚫ Connecting Audio
Connect Speaker to Audio line output and external Mic to Audio input line.
⚫ Connecting Service Monitor Port
Service monitor output port is located on the board of the camera.
* This camera does not support using the external OSD controller.