2
•
Configuration & Installation
XX074-02-01 Rev 703 Variable-Speed Keypad
Configuration & Installation
Warning: Do not connect this unit to a power source until all connections are complete.
In the installation figures that follow, the V1411X-DVC is shown. The figures are applicable to all three
variations of the keypad (V1411X-DVC, V1411J-DVC and V1410X-DVC). The keypad is shipped with the
following accessories:
•
RJ-45 termination box and RJ-45 cable
•
Power supply.
You will use these items as shown on the following pages, which describe the two system configurations
available when using the keypad:
•
Standalone (no control system, receivers/domes may be connected)
•
NOVA (NOVA control system or matrix switcher).
Power Requirements
A 12 VDC power supply is included for 120 VAC. For 230 VAC, a 9 VAC power supply is included. The two
leads will be connected to the RJ-45 termination box. You may connect the two leads to either of the
termination box screws shown in the figures to follow - polarity is not a factor for either the DC or the AC
supply.
Standalone
In a standalone system, there is no control system (CPU). You may connect receivers and domes directly to
the keypad in this configuration. The 4-wire half-duplex RS-422 protocol for the keypad is driven in a multi-
drop, tri-state manner that allows you to connect directly to Surveyor2000 domes, which use RS-485, without
the need for a converter box.
UP TO 255 RECEIVER/DOMES
V1411X-DVC
POWER SUPPLY
(Refer to Technical
Information for details)
RJ45-to-RJ45 CABLE
110 VAC or
230 VAC
RJ-45
TERMINATION
BOX
Recommended Data Cable
Belden 8723 8000 ft (2400 m)
Belden 8162 15,000 ft (4600 m)
Belden 9729 15,000 ft (4600 m)
Belden 9182 25,000 ft (7600 m)
COM. OUT +
12 VDC or
9 VAC AC
INPUT
RESP. IN +
COM. OUT –
NOT USED
GROUND
RESP. IN –
